Digi DC-190 Instruction Manual download pdf (Page 30)

Digitronic Digital Cam Switch Unit

Automationsanlagen GmbH CamCon DC190

6.4.2. Offline - Simulation

The Digisoft 2000 Program gives you the opportunity to simulate the encoders like the Measuring

System, hardware inputs (l) and backplane inputs (V) of an S7 (CamCon DC300 or ControlLogix 1756-

DICAM) in the "Offline" programming. This option makes it possible to test a PLC logic program on

your computer without having to install a CamCon or further machinery. This option is not available

"Online". The Digisoft 2000 program can be downloaded at http://www.digitronic.com.

6.5. Cam programming

Cam programming is used to select a program number for the programming of a cam. You can name

any program number (with a tool or recipe number, e.g.). Programmed cams are displayed graphical

on a scale in the resolution of the used measuring system. Maximum and minimum values (actual or

cam values) will be displayed to the left and right above the scale (e.g. 0° - 359°).

You can access the programming options by clicking the "Edit" button.

6.5.1. Entering Cams

The cam programming can be used to address a name to any cam output, to enter or edit the

switching points of the cams, to adjust the Delay Time compensation or to shift all cams of an output or

an output track stepwise.

In addition, the option "Programm Multicams" can be used to fill up a cam track with multiple cams

automatically.

Hint: If you let the cursor „hover“ above the green box of a cam, the switching points will be

displayed in a small pop up box.

Version from: 19.04.2012 Page: 30

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 63 64

No comments

Digi DC-190 Instruction Manual Page 30