Digi PortServer TS 8 Setup Guide download pdf (Page 22)

3-4 Configuring Ports for RealPort: Command Line

Configuring Ports for RealPort: Command Line

This section describes how to configure RealPort ports from the command line.

Procedure

Use this procedure to use the command line to configure PortServer TS 8/16 for RealPort.

This procedure assumes that you have signed on as root and have or will

• Install RealPort software on each RealPort host. See the appropriate RealPort documentation for

more information.

• Properly cabled PortServer TS 8/16 ports and devices.

• Set up the devices connected to PortServer TS 8/16 ports

1. Configure the RealPort TCP port by entering the following command:

set tcp realport=771

2. Configure PortServer TS 8/16 ports by entering the following command:

set ports range=range dev=rp

where range is the range of ports to which this command applies

Example:

set ports range=2 dev=rp

Example

In this example, all ports are configured for RealPort.

set tcp realport=771

set ports range=* dev=rp

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 105 106

No comments

Digi PortServer TS 8 Setup Guide Page 22