Digi DC-190 Specifications download pdf (Page 12)

3.0. INSTALLATION

This section provides the information required for installing this counting system

for operation. The following steps accomplish installation.

1. Unpacking

2. Set-up Procedure

3.1. Unpacking

Each component of the DC-190 system is packed in a specially designed carton.

Remove each component from its carton, separate the component from its

polystyrene shell assembly and set aside. Inspect the carton interior to be sure

that all accessories have been removed from the carton. Inspect the carton inner

panels for accessories.

NOTE: Be sure to repack all materials within the carton set. Store the cartons in

A secure area so they can be available whenever future shipment of the scale is

required.

3.2. Inspection

Immediately after unpacking, a visual inspection of the scale should be performed.

If any damage has been incurred during transportation notify the shipper and DIGI

MATEX, Inc. immediately. Instructions for assessment of damage and further

procedures will then be determined.

3.3. Repackaging

If, at anytime, the DC-190 counting scale must be returned for modification,

calibration, or repair, be sure that it is properly packed with sufficient cushioning

materials.

Whenever possible, the original carton assembly should be retained for this

purpose. Any damage caused by improper packaging will not be covered by

warranty.

3.4. Unlocking Procedure

The unlocking procedure is included on the next page. The DC-190 should

be properly locked whenever it is being transported.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 65 66

No comments

Digi DC-190 Specifications Page 12