4.8. Scale 1↔↔
↔↔
4 Operation :
Display in the weighing mode
Pressing [SCALE] key changes from Scale 1 to Scale 2.
Pressing [SCALE] key changes from Scale 2 to Scale 3
Pressing [SCALE] key changes from Scale 3 to Scale 4.
Pressing the [SCALE] key again changes back to Scale 1
Note: Default Position: The Position for Scale 1 to scale 4 can be set in Specs 16 &
Scale 1: Internal Scale 1 Scale 3: External Scale
Scale 2: Internal Scale 2 Scale 4: Force Balance
* NOTE: ONLY SCALES PRESENT WILL BE SELECTED. EX. 2 SCALE SYSTEM SWITCHES
BETWEEN SCALE 1 AND 2 ONLY.
4.9. Recall The Item Memory
4.9.1. Recall The Item Memory For Normal Operation:
1 Check if the scale is in normal mode
2 Enter code no [1] [2] [3]
3 Press [CODE] key to recall the data for item code 123
4 Put item on the platter
4.9.2. Recall The Item Memory: For Normal Operation (With 16 Digits Teraoka Code)
1 Check if the scale is in normal mode
2Press [••
••
] key for Teraoka Code Entry
3 Input 2 digit Teraoka Code. Example: Enter ‘A’ type [0 ] [1]
4 Press [++
++
] or [−−
−−
] to shift to right or left position
5 Input 2 digit Teraoka Code. Example: Enter ‘C’ type [0 ] [3]
6 Press [++
++
] or [−−
−−
] to shift to right or left position
7Press [CODE] key to call the Item Code
4.10. Recomputing Unit Weight In Memory: (See Spec 4 bit 3)
1 Display in the weighing mode
2 Recall an Item already in memory and weigh
3 Press [PIECES] key for recomputing
4 Press [UNIT WEIGHT] key to set the new unit weight into the memory
Comments to this Manuals