Digi ConnectPort X4 User's Guide download pdf (Page 112)

Configuration through the web interface

112

 Test only when idle: if no data is received for the above period of time: Specifies that

the test repeat interval (above) is to be used as an idle period interval. That is, initiate the

selected link integrity test only after no data has been received for the specified interval

of time. This changes the behavior of the test in that the test interval varies according to

the presence of other data received from the mobile connection.

Although using this idle option may result in less data being exchanged over the mobile

connection, it also prevents the link integrity tests from running as often to verify the

true bi-directional state of that connection.

 Reset the link after the following number of consecutive link integrity test failures:

Specifies that after the configured number of consecutive link integrity test failures, the

mobile connection should be disconnected and reestablished. This value must be

between 1 and 255. The default is 3. When the mobile connection is reestablished, the

“consecutive failures” counter is reset to zero.

If the mobile connection is disconnected for any reason (including not as a result of a

link integrity test failure), the consecutive failures count is reset to zero when the mobile

connection is reestablished.

Status and statistical information for mobile connections

Once the mobile settings have been configured, you can monitor the status of mobile connections

by going to Administration > System Information > Mobile. See "Mobile information and

statistics" on page 206.

From the command line, this mobile information is displayed by issuing display mobile and

display pppstats commands.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 270 271

No comments

Digi ConnectPort X4 User's Guide Page 112