Digi ConnectPort X4 User's Guide download pdf (Page 148)

Configuration through the web interface

148

TCP settings

The TCP Settings are displayed only when the current serial port is configured with the

TCP Sockets or the Custom Profile.The settings are as follows:

 Send Socket ID: Include an optional identifier string with the data sent over the

network. The Socket ID can be 1 to 256 ASCII characters. To enter non-printable

characters, use these key sequences:

 Send data only under any of the following conditions: Enable if it is required to set

conditions on whether the Digi device sends the data read from the serial port to the

TCP destination. Conditions include:

– Send when data is present on the serial line: Send the data to the network destinations

when a specific string of characters is detected in the serial data. Enter the string 1 to 4

characters in the Match String field. To enter non-printable characters, use these key

sequences:

– Strip match string before sending: Match string before sending to strip the string from

the data before it is sent to the destination.

– Send after the following number of idle: Send the data after the specified number of

milliseconds has passed with no additional data received on the serial port. This can be 1

to 65,535 milliseconds.

– Send after the following number of bytes: Send the data after the specified number of

bytes has been received on the serial port. This can be 1 to 65,535 bytes.

Character Key

Sequence

backspace \b

formfeed \f

tab \t

new line \n

return \r

backslash \\

hexadecimal

values

\xhh

Character

Key

Sequence

hexadecimal values \xhh

tab \t

line feed \n

backslash \\

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 270 271

No comments

Digi ConnectPort X4 User's Guide Page 148