Digi ConnectPort X4 User's Guide download pdf (Page 41)

Hardware installation for ConnectPort X4 H

Configuration settings and status information

There are several firmware settings for SIM cards, for selecting between dual SIM cards, designating primary and

secondary SIM cards, setting ID and phone numbers, and viewing status. See "SIM card selection and settings" on page

100.

Power cable fitting

Class 1, Div 2 units

Warning

Do not plug in or apply power to the unit until all connections are made to the

unit in the following steps.

For customers who have purchased a C1D2-approved unit with cable and conduit to wire into the

main power supply:

1 Make sure that the mains power to the junction box where the cable is to be wired into is off.

2 Wire the exposed end of the cable into the junction box using approved C1D2 wiring

regulations per National Electrical Code Article 501 (if located in the United States) and

other regulations applicable to the locality where it is installed.

See the Power cable wiring table below for information on wiring this cable to the

junction box. The mains voltage for this unit needs to be between 100VAC and 240VAC,

50Hz to 60 Hz, and be able to supply a minimum of 24 Watts.

The blue reset button inside the unit can be used to disconnect/reconnect power for units

that are hard-wired to power.

Non-Class 1, Div 2 units

For customers who have purchased a non-C1D2 approved unit with a standard power cord with a

plug on the end:

The unit can be plugged into a standard matching wall outlet that has an output between 100VAC to

240VAC, 50Hz to 60Hz, and capable of supplying at least 24 Watts.

There are three power-cord options available: U.S.A 120V, European 240V, and U.K. 240V.

Power cable wiring

Function Cable Wire Color Power Supply

Phoenix Connector

Pin Number

Frame Ground (FG) Green 1

Neutral (N) White 2

Line (L) Black 3

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 270 271

No comments

Digi ConnectPort X4 User's Guide Page 41