Digi ConnectPort X4 User's Guide Page 83

  • Download
  • Add to my manuals
  • Print
  • Page
    / 271
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 82
Configuration through the web interface
83
With the configuration described above, any frames sent from the 192.168.1.x
network to any IP address not in the 192.168.1.x subnet will be set over the VPN
tunnel to the remote subnet.
When configuring a Digi device for VPN tunnel all mode and the device allows for
setting the gateway priority, set the gateway priority. The gateway priority is set on
the Configuration > Network > Advanced Network Settings page in the
Gateway Priority setting. Set the gateway priority to Ethernet for
Ethernet-enabled Digi devices, or Wifi for a wireless Digi devices. If the Digi
device’s IP address on the Ethernet (or wireless) interface is statically configured,
specify the address for the gateway on that interface. The gateway address is set in
the Configuration > Network > Ethernet IP Settings page.
Pre-Shared Key Settings
If you select the pre-shared key authentication method in one or more of your ISAKMP
Phase 1 Policies, then you will be prompted to supply the ID of the VPN device and the
preshared key used for authentication.
Use the following IP address, FQDN, or username for the remote VPN’s ID: Enter
the remote VPN device’s ID here. Make sure the remote VPN device is configured to
send this ID.
Use the following pre-shared key to negotiate IKE security settings: Enter the
preshared key here. This must match exactly with the preshared key set on the remote
VPN device.
Page view 82
1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 270 271

Comments to this Manuals

No comments